North

Researchers look to sawdust to absorb, burn off Arctic oil spills

U.S. federal researchers looking for ways to contain petroleum spills in frigid Arctic waters are investigating whether a powder form of humble sawdust can provide a solution.

It 'allows you within a matter of minutes to remove upward of 90 per cent of the oil from the water'

In this Dec. 9, 2016 photo, courtesy of Pacific Northwest National Laboratory, microbiologist Robert Jeters sprinkles PNNL's chemically modified sawdust onto a small oil spill inside the Arctic simulation lab, where researchers mimic extreme freezing conditions and make icy slush that is similar to what can be found on the surface of the Arctic Sea. (Pacific Northwest National Laboratory via AP)

Federal researchers looking for ways to contain petroleum spills in frigid Arctic waters are investigating whether a powder form of humble sawdust can provide a solution.

Researchers at the Department of Energy's Pacific Northwest National Laboratory are testing chemically modified wood flour to determine whether it can enhance the burning of crude oil after a spill.

Tests of small batches treated with components of vegetable oil indicate the material will grab onto crude oil and help keep it near the surface. PNNL senior research scientist George Bonheyo, who is also a research professor of bioengineering at Washington State University, calls the material "incredibly buoyant, ice repelling and water-repelling."

"It really, really loves oil," Bonheyo said. "It absorbs at least five times its weight in oil."

Difficult environment for clean-ups

Environmental groups say challenges with cleaning an oil spill are amplified in the Arctic and it's one of their primary objections to drilling in Arctic waters. The location is far from ports and other infrastructure taken for granted at drilling sites such as the Gulf of Mexico. Storms are fierce and Arctic waters can be open, frozen or partially covered with ice ranging from floes to slush.

Mechanical recovery has not proven effective because ice can jam skimmers. Researchers at the PNNL lab have focused on burning and bioremediation.

"The point with doing a burn is that it allows you within a matter of minutes to remove upward of 90 per cent of the oil from the water," Bonheyo said.

A controlled oil spill burn, a practice used during the 2010 Deepwater Horizon disaster, can significantly reduce the amount of oil in water and minimize its adverse environmental effects. (Pacific Northwest National Laboratory via AP)
To burn, he said, untreated crude oil must be fresh and at least 3 mm thick, a little more than two stacked dimes. Early results from lab tests of the chemically treated sawdust indicate the material will help keep an oil slick together in the face of buffeting by wind, waves or ice, Bonheyo said, and allow it to burn in thinner amounts.

"We know we can get below one millimetre," he said. "We don't know exactly what the minimum thickness is."

Crude oil weathers when absorbed by the material but remains buoyant for at least four months.

"It works very well at holding a spill together. It seems to act kind of like a wick, allowing the volatile, flammable components to rise up to the surface to facilitate an efficient burn," Bonheyo said.

Microbes to consume oil not burned

Bonheyo has a background in research on preventing ship hulls from being fouled by organisms. Researchers are looking into adding a bioremediation element to the chemically modified sawdust. Mixtures of organisms adapted for different hydrocarbons, and adapted for different environments, could be added to the wood-based product.

"The idea there is, if any of the oil with the sawdust escaped a burn site, the microbes would be there to consume the escaped oil," Bonheyo said.

Researchers have conducted burn tests of Alaska North Slope crude oil and Gulf of Mexico crude in warm water at the Navy and Coast Guard Joint Marine Test Facility near Mobile, Alabama. Cold water testing is underway. Researchers also are analyzing residue of material that remains after burning.

During tests researchers have shaken the powdery material onto water surfaces or spread it with a modified leaf blower. In the real world, Bonheyo suggested, it might be dispersed the way powdery materials are distributed by crop dusters.

Comments

To encourage thoughtful and respectful conversations, first and last names will appear with each submission to CBC/Radio-Canada's online communities (except in children and youth-oriented communities). Pseudonyms will no longer be permitted.

By submitting a comment, you accept that CBC has the right to reproduce and publish that comment in whole or in part, in any manner CBC chooses. Please note that CBC does not endorse the opinions expressed in comments. Comments on this story are moderated according to our Submission Guidelines. Comments are welcome while open. We reserve the right to close comments at any time.

Become a CBC Member

Join the conversationCreate account

Already have an account?

now